Cost Effective Solutions to Space Management
THE COMPLETE SAFEGARDE PARTITION SYSTEM.
The Safegarde system lets you create areas that meet your every need !
Safegarde security partitions are ideal for large and small warehouses.
They ensure complete protection without interfering with the free circulation of air and light.
Safegarde security partitions are ideal for large and small warehouses.
They ensure complete protection without interfering with the free circulation of air and light.
SAVE TIME AND MONEY
The Safegarde system is so easy to assemble that the installation can be carried out by virtually anyone, thereby reducing installation cost by up to 50%
PART 1 - GENERALThe Safegarde system is so easy to assemble that the installation can be carried out by virtually anyone, thereby reducing installation cost by up to 50%
1.01 Related Work
1. The area where "SAFEGARDE" wire mesh enclosure is installed shall have a concrete slab, trowelled smooth and hard.
1.02 System Description
1. This document specifies a pre-engineered wire mesh enclosure system consisting of wire mesh panels, posts, doors and hardware.
1.03 Quality Assurance
1. System Manufacturer: Established firm with a minimum of 10 (ten) years experience in the design and fabrication of wire mesh enclosure systems.
2. Installation: Safegarde system can be installed by the end users labour, or EDWARD’S installers.
1.04 Warranty
1. The supplier shall warrant the "SAFEGARDE" wire mesh partition to be free from manufacturing defects for a period of 1 year.
2. Warranty does not cover maintenance, or damages caused by abuse and/or conditions beyond the control of the supplier.
PART 2 - PRODUCT SPECIFICATIONS
2.01 Approved Manufacturer
1. System Manufacturer:
SAFEGARDE - Distributed by EDWARDS DOOR SYSTEMS LIMITED
Tel: 1-888-786-5623 - Fax: 1-519-336-6063- e-mail:
2.02 Material
1. Panels: Frame shall be made of rolled formed angle 1 1/4" x 1 1/4" x 12ga. or 10ga. structurally shaped for extra strength. Corners shall be mitered and seam welded.
Fabric shall be 10ga (.134) clean bright wire, resistance welded at every joint and welded to the frame at every 6". 8' panels shall be rein forced with 2-1/2" round bar, dividing the panel in 3 equal sections.
2. Posts: Standard post shall be 8' high, 2" x 2" seam welded square steel tubing. Standard post spacing shall be either 8' or 10' centre.
Base plate shall be 6" x 2" x 1/4" with 2 elongated holes for easy adjustment.
3. Doors (Swing): Swing doors shall be made of the same material and method as the panels, plus a 1 1/4" x 1/8" flat steel bar welded across the center and two 1/2" round diagonals stay bars. Doors shall be equipped with a set of padlocking hasps, two door stoppers and 1 1/2" pair of steel pin hinges.
4. Doors (Sliding): Sliding doors shall be made of the same material and method as the panel, and are reinforced with 1-1/2" square tubing bolted to the front and rear leading edges. Doors shall be equipped with equivalent #68 Stanley track, two #64 hangers, door guide, receiver and a set of hasp for padlocking.
5. Roofs: Roof panels shall be made of the same material and method as regular panels and are designed for security purpose only. Roof panels are not live load bearing capable unless specifically designed for a specific load.
6. Finish: Finish shall be standard Cogan Gray enamel applied with hot airless electrostatic process. (Other colours available)
7. Hardware: All necessary assembly fasteners shall be provided except floor and wall anchors.
8. Installation: Erection of the "SAFEGARDE" Wire Mesh Partition shall be made in accordance with the instruction shown on the installation drawing and related documents.
SafeGarde Condominium Lockers
SafeGarde Wire-Mesh Lockers
PUT A LOCK ON, SECURE STORAGE WITH SAFEGARDE
The Safegarde system offers efficient protection for goods stored in condominiums and apartment buildings.
These systems are tough, fire-resistant, easy to install and virtually maintenance free. The units are made of welded wire-mesh which lets the air and light through, thereby eliminating any need to transform the storage area's lighting and ventilation systems. With the Safegarde system, you can turn an unused area into a practical and secure storage space at a minimum cost.
ECONOMICAL SAFEGARDE MULTI-PURPOSE LOCKERS ARE ENGINEERED FOR EASY INSTALLATION.
Doors and panels are constructed as single units. Anchor to the floor and wall as desired for rigidity and the job is done. All necessary hardware is included.
The frame of the panels and doors are made of 1 1/4" x 1 1/4" x 12ga cold rolled steel, formed for extra strength and rigidity. The wire-mesh is made of 2" x 2" x 10 gauge welded fabric. The door frames are equipped with steel pin hinges, door stops, and padlock hasps. Locks are not included. The components are electrostatically sprayed with medium blue or grey enamel.
48 HOUR DELIVERY
Typical Application Areas:
Aisleways Building walls Computer control centers Conveyors In-plant offices Inventory areas Heating / Cooling Equipment Freezer/Cooler panelsElectrical equipment Mezzanines Loading docks / Rack aisle endsMachinery Guard
Length
Diameter
Height
Model
36 "
4 "
24 "
MG-324
48 "
4 "
24 "
MG-424
36 "
4 "
42 "
MG-342
48 "
4 "
42 "
MG-442
Rack Guard
Length
Diameter
Height
Model
36 "
4 "
10 "
RG-3
48 "
4 "
10 "
RG-4
Bollards
...putting ideas
to work for you!
Diameter
Height
Model
4.5 "
24 "
B-24
4.5 "
36 "
B-36
4.5 "
42 "
B-42
NOTE: All material shall fabricated in accordance with our manufacturer's standards of design and fabrication and will be shipped complete in accordance with our standard shop drawings and/or manufacturer's details.
Please contact us for technical information, specifications and engineering details.
